Variant Work

Perform when replacing the combination meter assembly.

When communication with Subaru Select Monitor is possible («Read Control module setting information» is workable): Perform the operation procedure A.
When communication with Subaru Select Monitor is not possible («Read Control module setting information» is not workable): Perform the operation procedure B.

CAUTION:

Subaru Select Monitor is required for variant work.
If an error is displayed during the work, click the «OK» button and perform the variant work again.

Operation procedure A

Connect the Subaru Select Monitor.
On «Start» display, select «Diagnosis».
On «Vehicle selection» display, enter vehicle information and select «Confirmed».
On «Main Menu» display, select «Each System».
On «Select System» display, select «Combination Meter» and then select «Enter».
On «Select Function» display, select «Work Support».
From the work support list, select «Read Control module setting information».
Save and close the file.
Replace the combination meter assembly with a new part.
On «Main Menu» display, select «Each System».
On «Select System» display, select «Combination Meter» and then select «Enter».
On «Select Function» display, select «Work Support».
Select «Write ECU setting save data», and open the file stored in «Read Control module setting information».
When the confirmation screen indicating the vehicle information appears, check that the correct information is displayed and click the «OK» button.
Confirm that «Write operation was completed.» is displayed, and click the «OK» button.

Operation procedure B

Replace the combination meter assembly with a new part.
Connect the Subaru Select Monitor.
On «Start» display, select «Diagnosis».
On «Vehicle selection» display, enter vehicle information and select «Confirmed».
On «Main Menu» display, select «Each System».
On «Select System» display, select «Combination Meter» and then select «Enter».
On «Select Function» display, select «Work Support».
From the work support list, select «Write ECU setting 12 columns of models». Enter the applied model and click the «OK» button. <Ref. to IDENTIFICATION NUMBER & LABEL LOCATIONS , IDENTIFICATION, Identification.>
Enter the option code and click the «OK» button. <Ref. to IDENTIFICATION NUMBER & LABEL LOCATIONS , IDENTIFICATION, Identification.>
Confirm the vehicle information on «Write ECU setting 12 columns of models» display and click the «OK» button.
When «Write?» is shown on the screen, click the «Yes» button.
Confirm that «Write operation was completed.» is displayed, and click the «OK» button.