1 CHECK WARNING LIGHT.
Check whether the airbag warning light in the combination meter is lit. |
Does the airbag warning light illuminate? |
Go to step 2 |
Perform the diagnosis according to phenomenon of the problem. |
2 READ DTC.
- Turn the ignition switch to OFF.
- Connect the Subaru Select Monitor to data link connector.
- Turn the ignition switch to ON and run the Subaru Select Monitor.
- Read the DTC. Ref. to
OPERATION , Read Diagnostic Trouble Code (DTC).
NOTE:
If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. Ref. to
INSPECTION , Subaru Select Monitor.
- Record all DTCs and freeze frame data.
|
Is DTC displayed? |
Go to step 3 |
Go to "Airbag Warning Light Failure" Ref. to
AIRBAG WARNING LIGHT FAILURE |
3 PERFORM DIAGNOSIS.
- Determine the possible cause from "List of Diagnostic Trouble Code (DTC)" Ref. to
LIST OF DIAGNOSTIC TROUBLE CODE (DTC)
- Inspect the DTC using "List of Diagnostic Trouble Code (DTC)".
- Repair the trouble cause.
- Perform the Clear Memory Mode. Ref. to
CLEAR MEMORY MODE
- Perform the Inspection Mode. Ref. to
INSPECTION MODE
- Read any other DTCs displayed.
|
Is DTC displayed? |
Perform the procedure 1) to 5) in step 3. |
Finish the diagnosis. |