Preparation for Overhaul: Procedure

Clean the transmission exterior.
Attach the ST on the transmission assembly.
ST 18632AA000 STAND ASSY

Fig 1: Attaching Stand Assy (18632AA000) On Transmission Assembly
Courtesy of SUBARU OF AMERICA, INC.
Remove the torque converter assembly. <Ref. to TORQUE CONVERTER ASSEMBLY .>
Remove the transmission case cover on the transmission upper side.
NOTE: Install using the following tightening torque.

Tightening torque:

8 N.m (0.8 kgf-m, 5.9 ft-lb)

Fig 2: Transmission Case Cover
Courtesy of SUBARU OF AMERICA, INC.
Place the transmission assembly on end.
When completely overhauling the transmission, refill approx. 10 L (2.6 US qt, 8.8 Imp qt) of CVTF through the transmission right side plug, and install the plug. Then, install the transmission case cover.

CAUTION: Always use specified CVTF. Using other fluid will cause malfunction. <Ref. to HYDRAULIC CONTROL AND LUBRICATION , SPECIFICATION, General Description.>

NOTE: Use a new gasket.

Tightening torque:

50 N.m (5.1 kgf-m, 36.9 ft-lb)

Fig 3: Locating Transmission Right Side Plug

Courtesy of SUBARU OF AMERICA, INC.