Reduction Driven Gear: Assembly

Install the snap ring to reduction driven gear.
NOTE: Use a new reduction driven gear COMPL.
Using the ST, attach the collar.
NOTE: Attach the collar in the correct direction.

ST 899580100 INSTALLER

Fig 1: Attaching Collar Using Installer (899580100)
Courtesy of SUBARU OF AMERICA, INC.
Using the ST, install the parking gear.
ST 499757002 INSTALLER

Fig 2: Installing Parking Gear Using Installer (499757002)
Courtesy of SUBARU OF AMERICA, INC.
Using the ST, install the transfer drive gear.
ST 499757002 INSTALLER

Fig 3: Installing Transfer Drive Gear Using Installer (499757002)
Courtesy of SUBARU OF AMERICA, INC.
Using the ST, install the ball bearing.
NOTE: Use a new ball bearing.

ST 499277100 BUSHING 1-2 INSTALLER

Fig 4: Installing Ball Bearing Using Bushing 1-2 Installer (499277100)
Courtesy of SUBARU OF AMERICA, INC.
Using the ST, counter the rotation of the reduction drive gear assembly, and install the lock nut.
NOTE: Use a new lock nut.

ST1 18355AA000 PULLEY WRENCH

ST2 18334AA000 PIN SET

ST3 499987003 SOCKET WRENCH (35)

Tightening torque:

95 N.m (9.7 kgf-m, 70.1 ft-lb)

Fig 5: Countering Rotation Of Reduction Driven Gear Assembly Using Special Tools
Courtesy of SUBARU OF AMERICA, INC.
Crimp the lock nut at four locations so that the dimension of A becomes 18.9 mm (0.74 in) or less.

CAUTION: Do not allow the lock nut to be cracked during crimping operation.

Fig 6: Locknut Crimping Dimensions

Courtesy of SUBARU OF AMERICA, INC.