Intermediate Case: Installation

Clean the mating surface of intermediate case and transmission case.
Face the O-ring side of the CVTF filter to the intermediate case side, and install the CVTF filter.
NOTE: Apply CVTF to the O-rings.

Fig 1: Identifying CVTF Filter
Courtesy of SUBARU OF AMERICA, INC.
Install the O-ring to the transmission case.
NOTE:
- Use new O-rings.
- Apply CVTF to the O-rings.
Fig 2: Identifying Identifying O-Rings
Courtesy of SUBARU OF AMERICA, INC.
Apply liquid gasket to intermediate case seamlessly.
Liquid gasket:

THREE BOND 1215B or equivalent

Fig 3: Liquid Gasket Application Area - Intermediate Case
Courtesy of SUBARU OF AMERICA, INC.
Install the intermediate case and the transmission hanger to the transmission case.
NOTE: Make sure to install the arrowed bolt.

Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)

Fig 4: Identifying Transmission Inside Bolt
Courtesy of SUBARU OF AMERICA, INC.
Install the transfer reduction driven gear assembly. Ref. to INSTALLATION , Transfer Reduction Driven Gear.
Install the transfer clutch assembly. Ref. to INSTALLATION , Transfer Clutch.
Install the rear drive shaft. Ref. to INSTALLATION , Rear Drive Shaft.
Install the parking pawl. Ref. to INSTALLATION , Parking Pawl.
Install the extension case. Ref. to INSTALLATION , Extension Case.
Install the transmission to vehicle. Ref. to INSTALLATION , Automatic Transmission Assembly.