FixVault
Home › Subaru › 2017 › WRX Base › Repair and Diagnosis › Body & Frame › Door Locks › Anti-Theft System - Security And Locks › Front Outer Handle › Installation

Front Outer Handle: Installation

  1. Before installation, check the following items.
    • Rod is free from deformation.
    • Grease is applied sufficiently to rod joints.

    If grease is insufficient, add it as necessary before assembling the rod.

    • If the rod is deformed, replace the latch & actuator assembly - front.
  2. Install the frame assembly - front door outer.

    Preparation tool: 

    TORX® T30 

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb) 

  3. Install the spacer - door handle outer.
  4. Install the handle - door outer.
    NOTE: For model with keyless access with push button start, connect the harness clip and exterior antenna (touch sensor) connector.
    1. Insert the end of the handle - door outer to the frame assembly - front door outer.
    2. Push forward while inserting the rear end of the handle - door outer to the frame assembly - front door outer.
  5. Install the cover - handle front outer.
    CAUTION: When installing the cover - handle front outer on driver's side, make sure that the key cylinder shaft is correctly inserted into the latch & actuator assembly - front  .

    Preparation tool: 

    TORX® T30 

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb) 

  6. Install the sealing cover - front door.
  7. Install the trim panel - front door.
  8. Connect the battery ground terminal. <Ref. to BATTERY , NOTE, Note.>
About FixVault