FixVault
Home › Subaru › 2017 › WRX Base › Repair and Diagnosis › External Pages › Different car › Section 29 (Fuel Injection System) › Oil Control Solenoid › Installation › Intake › LH Side

LH Side

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the backup ring to the oil control solenoid.
  2. Using a new O-ring, install the oil control solenoid.
    NOTE:

    Apply engine oil to O-ring. 

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

  3. Connect the connector.
  4. Hold the engine wiring harness with the clip.
  5. Install the reservoir tank. Ref. to COOLING (H4DOTC)>RESERVOIR TANK>INSTALLATION
  6. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
About FixVault