Section 2 (Engine Cooling System (2.0L)): Radiator: Installation

WARNING: This page is about a different variant/trim than selected.

Attach the radiator lower cushion to the radiator lower bracket.

Fig 1: Locating Radiator Lower Cushion
Courtesy of SUBARU OF AMERICA, INC.
Install the radiator to vehicle.
NOTE: Make pins on the lower side of radiator be fitted into the radiator lower cushions.
Install the radiator upper brackets.
Tightening torque:

12 N.m (1.2 kgf-m, 8.9 ft-lb)

Fig 2: Locating Radiator Upper Brackets Bolts
Courtesy of SUBARU OF AMERICA, INC.
Connect the radiator inlet hose to the water tank pipe assembly.

Fig 3: Locating Radiator Inlet Hose Clamp
Courtesy of SUBARU OF AMERICA, INC.
Connect the connector (A) to the main fan motor and the connector (B) to the sub fan motor.

Fig 4: Identifying Main Fan Motor Connector
Courtesy of SUBARU OF AMERICA, INC.

Fig 5: Identifying Sub Fan Motor Connector
Courtesy of SUBARU OF AMERICA, INC.
Lift up the vehicle.
Connect the radiator outlet hose to thermostat cover.

Fig 6: Locating Radiator Outlet Hose And Thermostat Cover Clamp
Courtesy of SUBARU OF AMERICA, INC.
Install the under cover. Ref. to INSTALLATION , Front Under Cover.
Lower the vehicle.
Install the reservoir tank. Ref. to INSTALLATION , Reservoir Tank.
Install the air intake duct. Ref. to INSTALLATION , Air Intake Duct.
Connect the ground terminal to battery sensor. Ref. to BATTERY , NOTE, Note.
Fill engine coolant. Ref. to FILLING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant.