Toe Control Link: Installation
NOTE:
- The following procedure is for LH side.
- Service the LH side and the RH side using the same procedure.
- Temporary tightening of toe control link SUB-ASSY LH
- After inserting the toe adjust cam from the front of the vehicle, install the toe control link SUB-ASSY LH and temporarily tighten it with the toe adjust plate No. 2 using a new nut.CAUTION: Align the alignment marks of the rear suspension member SUB-ASSY and the toe adjust plate No. 2.
- Install the toe control link to the axle carrier, and tighten it with the nut.
Standard value: T=60N.m {612kgf.cm} {44.3ft.lbf}
- Install a new snap pin.
- After inserting the toe adjust cam from the front of the vehicle, install the toe control link SUB-ASSY LH and temporarily tighten it with the toe adjust plate No. 2 using a new nut.
- Temporary tightening of rear suspension arm ASSY No. 1 LH (Refer to INSTALLATION , Step 5 )
- Stabilization of vehicle (Refer to INSTALLATION , Step 4 )
- Final tightening of toe control link SUB-ASSY LH
- Fully tighten the nut on the side of the rear suspension member SUB-ASSY.
Standard value: T=100N.m {1020kgf.cm} {73.8ft.lbf}
CAUTION: Make sure that the alignment marks of the rear suspension member SUB-ASSY and the toe adjust plate No. 2 are aligned.
- Fully tighten the nut on the side of the rear suspension member SUB-ASSY.
- Final tightening of rear suspension arm ASSY No. 1 LH (Refer to INSTALLATION , Step 8 )
- Installation of rear tire
Standard value: T=120N.m {1224kgf.cm} {88.5ft.lbf}
- Inspection and adjustment of rear wheel alignment (Refer to REAR WHEEL ALIGNMENT )
- Initialization of head light leveling computer (refer to AUTO LEVELING SYSTEM )
- Headlight beam adjustment (Refer to ADJUSTMENT )
- VDC sensor mid point setting (Refer to WORK SUPPORT )