FixVault
Home › Subaru › 2018 › Outback 2.5i › Repair and Diagnosis (Single Page) › Body & Frame › Door Locks › Anti-Theft System - Security And Locks › Keyless Entry Control Module › Removal › Outback Model

Outback Model

  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the trim panel - rear apron RH. Ref. to EXTERIOR/INTERIOR TRIM>Rear Quarter Trim>REMOVAL>OUTBACK MODEL .
  3. Remove the keyless entry control module.
    1. Disconnect the connector.
    2. Remove the bolt and then remove the keyless entry control module.
    G10272970Courtesy of SUBARU OF AMERICA, INC.
About FixVault