FixVault
Home › Subaru › 2018 › Outback 2.5i › Repair and Diagnosis › Body & Frame › Door Locks › Anti-Theft System - Security And Locks › Impact Sensor › Operation › Impact Sensor Setting Using SUBARU Select Monitor

Impact Sensor Setting Using SUBARU Select Monitor

  1. Make an impact sensor setting.
    1. Connect the Subaru Select Monitor to data link connector.
      NOTE: For detailed operation procedures, refer to "Application help".
    2. Turn the ignition switch to ON.
    3. On «Start» display, select «Diagnosis».
    4. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
    5. On «Main Menu» display, select «Each System».
    6. On «Select System» display, select «Body Control» and then select «Enter».
    7. On «Select Function» display, select «Customize».
    8. From the Customize item list, select «Impact sensor» and «Impact Sensor Setup».
    9. Make an impact sensor setting.
      • When installing: ON
      • When removing: OFF
    10. Make an impact sensor ON/OFF setting.
      • When installing: ON
      • When removing: OFF
    11. Turn the ignition switch to OFF, and then remove the Subaru Select Monitor.
About FixVault