Rear Lock Button: Installation
CAUTION:
Make sure that the harness grommet is securely installed.
If not properly installed, this may cause leaks.
If not properly installed, this may cause leaks.
- Install the rear lock button and the switch - opener rear gate.
- Install the garnish assembly - rear gate. Ref. to EXTERIOR/INTERIOR TRIM>Rear Gate Garnish>INSTALLATION
.
Tightening torque:
4.5 N.m (0.4 kgf-m, 3.3 ft-lb)
- Install the trim panel - rear gate. Ref. to EXTERIOR/INTERIOR TRIM>Rear Gate Trim>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .