FixVault
Home › Subaru › 2018 › Outback 2.5i › Repair and Diagnosis › Body & Frame › Door Locks › Anti-Theft System - Security And Locks › Rear Lock Button › Removal

Rear Lock Button: Removal

NOTE:
  • The rear lock button is integrated with the switch - opener rear gate.
  • Open the panel - rear gate before disconnecting the ground terminal from battery sensor.
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the trim panel - rear gate. Ref. to EXTERIOR/INTERIOR TRIM>Rear Gate Trim>REMOVAL .
  3. Remove the garnish assembly - rear gate. Ref. to EXTERIOR/INTERIOR TRIM>Rear Gate Garnish>REMOVAL .
  4. Remove the rear lock button.
    1. Remove the garnish switch bracket from the garnish assembly - rear gate.
    2. Release the locks at both ends of the button - opener rear gate by pushing them with a flat tip screwdriver, and remove the button - opener rear gate.
    3. Remove the screws and detach the rear lock button.
    G10272998Courtesy of SUBARU OF AMERICA, INC.
About FixVault