Secondary Pressure Sensor: Installation

CAUTION:

Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.
After installing the secondary pressure sensor, adjust the CVTF level.

Install the secondary pressure sensor.
NOTE:
- Use new O-rings.
- Apply CVTF to the O-rings.
Tightening torque:

39 N.m (4.0 kgf-m, 28.8 ft-lb)
Connect the harness connector.
Lower the vehicle.
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Refill CVTF to adjust the CVTF level. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION(TR580)>CVTF .