FixVault
Home › Subaru › 2018 › WRX Base › Repair and Diagnosis › Engine Mechanical › Cooling Fan › Engine Cooling System (Except For STI) › Radiator › Installation

Engine Cooling System (Except For STI): Radiator: Installation

  1. Attach the radiator lower cushion to the radiator lower bracket.
    G09476466
  2. Install the radiator to vehicle.
    NOTE: Make pins on the lower side of radiator be fitted into the radiator lower cushions.
  3. Install the radiator upper brackets.

    Tightening Torque: 

    12 N.m (1.2 kgf-m, 8.9 ft-lb)

    G10267245
  4. Connect the radiator inlet hose to the water tank pipe assembly.
    G10267244
  5. Connect the connector (A) to the main fan motor and the connector (B) to the sub fan motor.
    G09480796
    G09480797
  6. Lift up the vehicle.
  7. Connect the radiator outlet hose to thermostat cover.
    G10267241
  8. Install the under cover. Ref. to EXTERIOR/INTERIOR TRIM>Front Under Cover>INSTALLATION .
  9. Lower the vehicle.
  10. Install the reservoir tank. Ref. to COOLING(EXCEPT FOR STI)>Reservoir Tank>INSTALLATION .
  11. Install the air intake duct. Ref. to INTAKE (INDUCTION) (EXCEPT FOR STI)>Air Intake Duct>INSTALLATION .
  12. Connect the ground terminal to battery sensor. Ref. to NOTE>NOTE>BATTERY .
  13. Fill engine coolant. Ref. to COOLING(EXCEPT FOR STI)>Engine Coolant>REPLACEMENT>FILLING OF ENGINE COOLANT .
About FixVault