FixVault
Home › Subaru › 2018 › WRX Base › Repair and Diagnosis › External Pages › Different variant/trim › Section 6 (Engine Cooling System (STI)) › Radiator › Installation

Section 6 (Engine Cooling System (STI)): Radiator: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Attach the radiator lower cushion to the radiator lower bracket.
    G10265569
  2. Install the radiator to vehicle.
    NOTE: Make pins on the lower side of radiator be fitted into the radiator lower cushions.
  3. Install the radiator upper brackets.

    Tightening Torque:

    12 N.m (1.2 kgf-m, 8.9 ft-lb)

    G10265568
  4. Connect the two engine coolant hoses to the radiator and over flow pipe.
    G08539506
  5. Connect the radiator inlet hose.
    G08539505
  6. Lift up the vehicle.
  7. Connect the radiator outlet hose.
    G08539497
  8. Connect the connector (A) to the main fan motor and the connector (B) to the sub fan motor.
    G08539502
    G08539503
  9. Install the under cover. Ref. to EXTERIOR/INTERIOR TRIM>Front Under Cover>INSTALLATION .
  10. Lower the vehicle.
  11. Install the reservoir tank. Ref. to COOLING(STI)>Reservoir Tank>INSTALLATION .
  12. Install the air intake duct. Ref. to INTAKE (INDUCTION) (STI)>Air Intake Duct>INSTALLATION .
  13. Connect the battery ground terminal.
  14. Fill engine coolant. Ref. to COOLING(STI)>Engine Coolant>REPLACEMENT>FILLING OF ENGINE COOLANT .
About FixVault