Unit Inspection

LOCK ASSY - FUEL 

1. Check lock assembly - fuel

   Check the fuel lock operation when battery voltage is applied between the connector terminals.

   Preparation tool: 

   Circuit tester

   Courtesy of SUBARU OF AMERICA, INC.

   Terminal No.	Inspection conditions	Specification
   1 (+) - 2 (-)	Connect battery to the terminals	OPEN

2. Replace the lock assembly - fuel if faulty is found in the inspection.

FUEL FLAP STATUS SWITCH 

1. Check fuel flap status switch

   Measure the resistance between connector terminals.

   Preparation tool: 

   Circuit tester

   Courtesy of SUBARU OF AMERICA, INC.

   Terminal No.	Inspection conditions	Standard
   1 - 2	When the switch is not pressed	Less than 1 Ω
   	When the switch is pressed	1 MΩ or more

2. Replace the saucer - COMPL if faulty is found in the inspection.

REFUELING REQUEST SWITCH 

1. Measure the resistance between connector terminals.

   Preparation tool: 

   Circuit tester

   Courtesy of SUBARU OF AMERICA, INC.

   Terminal No.	Inspection conditions	Standard
   1 - 4	OFF	1 MΩ or more
   	ON	Less than 1 Ω

2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.
   CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
   Incorrect polarity connection may cause LED damage inside the switch.

   Terminal No.	Inspection conditions	Specification
   2 (+) - 3 (-)	Apply battery voltage.	Light ON

3. Replace the refueling request switch if faulty is found in the inspection.