FixVault
Home › Subaru › 2019 › Outback 2.5i › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Engine Cooling System (3.6L)) › Radiator Fan Control Unit › Removal › Radiator Fan Control Module (Main)

Radiator Fan Control Module (Main)

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover.
    1. Carefully pull up the rear of collector cover at two positions (A).
    2. Carefully pull up the front of collector cover at two positions (B) while moving it forward.
      G11585612Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  3. Remove the air intake duct. Ref. to INTAKE (INDUCTION) (H6DO)>AIR INTAKE DUCT>REMOVAL .
  4. Disconnect the radiator fan harness connector (A) and radiator main fan motor connector (B) from the radiator fan control module (main).
  5. Remove the bolts securing the radiator fan control module (main), and remove the radiator fan control module (main).
    G10264217Courtesy of SUBARU OF AMERICA, INC.
About FixVault