FixVault
Home › Subaru › 2019 › Outback 2.5i › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Engine Cooling System (3.6L)) › Radiator Fan Control Unit › Removal › Radiator Fan Control Module (Sub)

Radiator Fan Control Module (Sub)

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor, Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the air intake duct. Ref. to INTAKE (INDUCTION) (H6DO)>AIR INTAKE DUCT>REMOVAL .
  3. Disconnect the radiator fan harness connector (A) and radiator sub fan motor connector (B) from the radiator fan control module (sub).
  4. Remove the bolts securing the radiator fan control module (sub), and remove the radiator fan control module (sub).
    G10264218Courtesy of SUBARU OF AMERICA, INC.
About FixVault