FixVault
Home › Subaru › 2019 › Outback 3.6R Limited › Repair and Diagnosis › Engine Mechanical › Engine Lubrication System (3.6L) › Oil Level Switch › Removal

Oil Level Switch: Removal

  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the under cover, Ref. to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>REMOVAL .
  3. Drain the engine oil. Ref. to LUBRICATION (H6DO)>Engine Oil>REPLACEMENT .
  4. Disconnect the connector of the oil level switch from the engine harness, and remove the clip securing the harness to the front camshaft cap (LH) and the cylinder head (LH).
    G10264249Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the oil level switch from the oil pan upper.
    G10264250Courtesy of SUBARU OF AMERICA, INC.
About FixVault