FixVault
Home › Subaru › 2019 › Outback 3.6R Touring › Repair and Diagnosis › Transmission › Automatic Trans › CVT Transaxle (Tr690) › Primary Speed Sensor › Removal

Primary Speed Sensor: Removal

CAUTION: Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, replace with a new part.
  1. Remove the collector cover.
    1. Carefully pull up the rear of collector cover at two positions (A).
    2. Carefully pull up the front of collector cover at two positions (B) while moving it forward.
    G10263528Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  3. Loosen the clamp (A) which connects the air intake boot.
  4. Loosen the bolt (B) securing the air intake boot to the collector cover bracket.
    G11585613Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the air intake boot from the throttle body and the air cleaner case (rear), and move it to the left side wheel apron.
    CAUTION: Be careful not to allow the air intake boot to contact the air conditioner pipe.
    G11585614Courtesy of SUBARU OF AMERICA, INC.
  6. Clean the transmission exterior.
  7. Disconnect the harness stay.
    G10275976Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the primary speed sensor harness connector.
    G09481936Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the primary speed sensor.
    G09482007Courtesy of SUBARU OF AMERICA, INC.
About FixVault