FixVault
Home › Subaru › 2019 › WRX Base › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (CVT Transaxle) › Reduction Driven Gear › Removal

Reduction Driven Gear: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission from the vehicle. Refer to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>AUTOMATIC TRANSMISSION ASSEMBLY>REMOVAL .
  2. Remove the extension case. Refer to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>EXTENSION CASE>REMOVAL .
  3. Remove the rear drive shaft. Refer to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>REAR DRIVE SHAFT>REMOVAL .
  4. Remove the transfer clutch assembly. Refer to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>TRANSFER CLUTCH>REMOVAL .
  5. Remove the center differential carrier. Refer to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>CENTER DIFFERENTIAL CARRIER>REMOVAL .
  6. Remove the transfer reduction driven gear assembly. Refer to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>TRANSFER REDUCTION DRIVEN GEAR>REMOVAL .
  7. Remove the intermediate case. Refer to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>INTERMEDIATE CASE>REMOVAL .
  8. Remove the forward clutch assembly. Refer to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>FORWARD CLUTCH ASSEMBLY>REMOVAL .
  9. Remove the snap ring.
    G06654605Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the reduction driven gear assembly.
    G06654606Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the straight pin.
    G06654607Courtesy of SUBARU OF AMERICA, INC.
About FixVault