Secondary Pressure Sensor: Removal
CAUTION:
- Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.
- When removing secondary pressure sensor, CVTF may let out. If CVTF has leaked, adjust the CVTF level after installing the secondary pressure sensor.
- Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
- Lift up the vehicle.
- Clean the transmission exterior.
- Remove the secondary pressure sensor harness connector.
- Remove the secondary pressure sensor.NOTE: Use Ko-ken 3/8 12-point 27 mm (manufacturer product No. 3305M-27) deep socket.