Rain Sensor: Inspection

When removing or replacing the sensor assembly rain, perform the initial setting.
1. Turn the lighting switch and wiper switch to OFF.
2. Connect the Subaru Select Monitor.
  NOTE: For detailed operation procedures, refer to "Help" of application.
3. On [Start] screen, select [Diagnosis].
4. On [Vehicle selection] screen, input the target vehicle information and select [OK].
5. On [Main Menu] screen, select [Each System].
6. On [Select System] screen, select [Integ. Unit Mode], and then select «Enter».
7. On [Select Function] screen, select [Data monitor].
8. On [Data monitor], check that the display of [Rain drop Detection Sensor Setting] shows "OK".
9. On [Select System] screen, select [Automatic Light and Wiper], and then select [Enter].
10. On [Select Function] screen, select [Work Support].
11. On [Work Support], select [Sensor initial setting] to perform.
If the system does not operate normally after the initial setting, refer to AUTOMATIC LIGHT AND WIPER (DIAGNOSTICS). Ref. to AUTOMATIC LIGHT AND WIPER (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE .