FixVault
Home › Subaru › 2020 › BRZ Limited, Automatic Trans › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle (Service Information) › Neutral Start Switch ASSY › Removal

Neutral Start Switch ASSY: Removal

  1. Disconnection of the battery ground terminal (Refer to REMOVAL )
  2. Removal of under cover front AL (refer to REMOVAL )
  3. Removal of under cover COMPL T/M (refer to REMOVAL )
  4. Removal of exhaust pipe ASSY FR (refer to REMOVAL )
  5. Disconnection of floor shift gear shifting rod SUB-ASSY No. 1
    1. Remove the snap pin, the wave washer, and the shaft. Then, disconnect the floor shift gear shifting rod SUB-ASSY No. 1 from the control shaft lever RH.
      G12587480Courtesy of SUBARU OF AMERICA, INC.
  6. Removal of control shaft lever RH
    1. Remove the nut and the spring washer, and then remove the control shaft lever RH from the neutral start switch ASSY.
      G12587481Courtesy of SUBARU OF AMERICA, INC.
  7. Removal of neutral start switch ASSY
    1. Disconnect the connector from the neutral start switch ASSY.
    2. Use a thin flat tip screwdriver to release the crimping of the nut stopper and remove the nut and the nut stopper.
      G12587482Courtesy of SUBARU OF AMERICA, INC.
    3. Remove the bolt and then remove the neutral start switch ASSY.
      G12587483Courtesy of SUBARU OF AMERICA, INC.
      NOTE: Do not turn the manual valve shaft lever before installing the neutral start switch ASSY. If the manual valve shaft lever is turned, it may be disconnected inside AT.
About FixVault