Power Rear Gate Control Module: Removal

CAUTION: When the power rear gate CM is replaced, the memory height function is initialized. Be sure to measure the power rear gate height before starting the operation and set the memory height function again after the operation.

1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Refer to REPAIR CONTENTS>NOTE>BATTERY .
2. Remove the rear seat cushion assembly. Refer to SEATS>REAR SEAT>REMOVAL .
3. Remove the trim panel assembly apron LH and the trim panel rear pillar UPR LH. Refer to EXTERIOR/INTERIOR TRIM>REAR QUARTER TRIM>REMOVAL .
4. Remove the power rear gate Control Module.
   1. Disconnect the connectors in the following (a) - (c) order.

      Courtesy of SUBARU OF AMERICA, INC.

      NOTE: When the connectors are not disconnected in the sequence, a diagnosis code (DTC) may be detected.
   2. Release the lock and hook, and remove the power rear gate Control Module.

Courtesy of SUBARU OF AMERICA, INC.