Rear Lock Button: Installation
CAUTION:
Make sure that the harness grommet is securely installed.
If not properly installed, this may cause leaks.
If not properly installed, this may cause leaks.
- Install the switch request (lock).
- Install the switch opener rear gate. Refer to SECURITY AND LOCKS>REAR GATE OPENER BUTTON>INSTALLATION .
- Install the garnish assembly rear gate LWR. Refer to EXTERIOR/INTERIOR TRIM>REAR GATE GARNISH>ASSEMBLY .
- Install the garnish assembly rear gate.
Tightening torque:
4.5 N.m (0.5 kgf-m, 3.3 ft-lb)
- Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .