Satellite Switch Assembly
CAUTION:
- Before handling the airbag system components, refer to AIRBAG SYSTEM>General Description>CAUTION .
- Do not allow harness and connectors to interfere or get tangled up with other parts.
- If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
- If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC(VDC) Centering Mode" of the VDC. Refer to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .
- Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper installation.
- Install the satellite switch. Refer to POWER ASSISTED SYSTEM (POWER STEERING)>Steering Wheel>ASSEMBLY .
- Align the center position of the steering roll connector. Refer to AIRBAG SYSTEM>Roll Connector>ADJUSTMENT .
- Install the steering wheel. Refer to POWER ASSISTED SYSTEM (POWER STEERING)>Steering Wheel>INSTALLATION .
- Install the driver's airbag module. Refer to AIRBAG SYSTEM>Driver's Airbag Module>INSTALLATION .
- Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .