Seat System - Seats: General Description: Caution
- When performing service operation, refer to "Repair Contents" in "General Description". Refer to REPAIR CONTENTS>REPAIR CONTENTS .
- Refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Refer to AIRBAG SYSTEM>General Description>CAUTION .
- Before performing vehicle maintenance, turn the ignition switch to OFF and disconnect the ground terminal from the battery sensor, Refer to REPAIR CONTENTS>NOTE>BATTERY .
- When replacing the parts provided with memory functions, record the memory contents before disconnecting the ground terminal from the battery sensor.
- For model with door mirror interlocked seat position memory, be careful with the following items when disconnecting the ground terminal from the battery sensor.
When the seat or the door mirror is moved with the engine OFF, always disconnect the ground terminal from the battery sensor after waiting for 60 seconds. If the ground terminal is disconnected from the battery sensor without waiting for 60 seconds, the seat recalling position may be misaligned.
- Be careful not to damage the vehicle when taking out the seat from the vehicle.
- The load sensor of the occupant detection system of the passenger's seat is fixed to the cushion frame assembly. Never remove the load sensor from the cushion frame assembly. The following parts can be replaced as a single unit.
- Cushion pad
- Cushion cover
- Seat harness
- Panel front wire
- Lever towel bar
- When the cushion frame assembly of the passenger's seat is replaced, the seat harness and load sensor are assembled. When replacing the cushion frame assembly, do not touch the load sensor to avoid electrical damage.
- Before assembling, make sure how the harnesses such as side airbag harness and front seat belt INN harness are routed in order to avoid mis arranging. Assembling with harnesses improperly routed may cause the harness to get caught and short out.
- If the seat surfaces of backrests and seat cushions are removed, make sure to replace hang wires and hog rings with new parts.
- ECM seat memory must be initialized if the following conditions are met. (With door mirror interlocked seat position memory)
- When the driver's seat is replaced
- When the connector under the driver's seat is disconnected
- When the parts of the driver's seat is replaced.
- When the ECM seat memory is replaced.
- When the ground terminal is removed from the battery sensor
- When the battery is replaced
- When the fuse is removed.
- When the accessories are installed