Electronic Parking Brake Indicator Light Is Blinking

Detecting condition:

When VDCCM&H/U was replaced
When fault was detected or electronic parking brake switch was operated under faulty condition
When electronic parking brake switch was operated during maintenance mode
When electronic parking brake was operated while the vehicle was running on the free roller or while the tires were rotating with a help of the free roller
When electronic parking brake was operated with the brake high in temperature or operated on a steep slope

Trouble symptom:

Electronic parking brake may not operate properly.

CHECK VDCCM&H/U .
NOTE: If VDCCM&H/U was not replaced, start the diagnosis from step 2.

Was electronic parking brake operated after replacement of VDCCM&H/U?

Yes : Go to 2.

No : It is normal if the electronic parking brake operation indicator light comes on by operating the electronic parking brake and goes off by disengaging.
CHECK ELECTRONIC PARKING BRAKE WARNING LIGHT .
Turn the ignition switch to ON. (Engine OFF)

Does electronic parking brake warning light illuminate?

Yes : Perform the diagnosis according to the DTC. Refer to BRAKE CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

No : Go to 3.
CHECK VEHICLE CONDITION .
Is the brake condition other than overheating?

Is the electronic parking brake is operated except on a steep road?

Yes : Normal.

No : Go to 4.
CHECK DRIVING CONDITION .
Was the vehicle running except on the free roller?

Yes : Normal.

No : Go to 5.
CHECK OPERATION OF ELECTRONIC PARKING BRAKE .
1. Using the Subaru Select Monitor, perform the clear memory of [Brake Control]. Refer to COMMON (DIAG)>CLEAR MEMORY .
2. Execute the inspection mode. Refer to BRAKE CONTROL (DIAGNOSTICS)>Inspection Mode .
  Does electronic parking brake operation indicator light blink?
  
  Yes : Replace the VDCCM&H/U. Refer to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM&H/U) .
  
  No : Electronic parking brake was temporarily prohibited.