When The CROSSMEMBER COMPL Front Was Removed
WARNING: This page is about a different variant/trim than selected.
- Use a new O-ring to install the oil level switch, and secure the harness with the clip.NOTE: Apply engine oil to O-ring.
Tightening torque:
6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
- Secure the harness with clip, and connect the connector.
- Install the crossmember COMPL front. Refer to FRONT SUSPENSION>Crossmember>INSTALLATION .
- Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .