Oil Pressure Switch: Installation

WARNING: This page is about a different variant/trim than selected.

Apply seal material to the bolt threads of oil pressure switch.
NOTE: Before applying the seal material, degrease the oil pressure switch and the thread portions of the chain cover.

Seal material:

THREE BOND 1324 (Part No. 004403042) or equivalent
Install the oil pressure switch, and connect the connector.
Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)
Check the engine oil level and replenish the engine oil if necessary. Refer to LUBRICATION (H4DOTC)>Engine Oil>INSPECTION .
Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .