Crankshaft Position Sensor: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the crankshaft position sensor and connect the connector.
Tightening torque:
6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
- Install the engine ground and the harness case.
Tightening torque:
19 N.m (1.9 kgf-m, 14.0 ft-lb)
- Install the clip (B) to the engine wiring harness bracket.
- Connect the connector (A).
- Install the air intake boot. Refer to INTAKE (INDUCTION) (H4DO)>Air Intake Boot>INSTALLATION .
- Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .