FixVault
Home › Subaru › 2021 › Ascent Base › Repair and Diagnosis › Accessories & Equipment › Headlights › Lighting System › High-mounted Stop Light › Installation

High-mounted Stop Light: Installation

CAUTION: Make sure the bolt is tightened securely because improper installation of the spoiler assembly roof may cause water leakage.
  1. Install the stop light assembly high-mounted.

    Tightening torque: 

    4.5 N.m (0.5 kgf.m, 3.3 ft.lb)

  2. Install the spoiler assembly roof, Ref. to EXTERIOR/INTERIOR TRIM>Roof Spoiler>INSTALLATION .

    Tightening torque: 

    7.5 N.m (0.8 kgf.m, 5.5 ft.lb)

  3. Install the sensor touch assembly. (Model with power rear gate) Ref. to POWER REAR GATE SYSTEM>Power Rear Gate Touch Sensor>INSTALLATION .
  4. Install the drip rear gate. (Model without power rear gate)
  5. Install the trim panel assembly rear gate, Ref. to EXTERIOR/INTERIOR TRIM>Rear Gate Trim>INSTALLATION .
  6. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
About FixVault