Rear Combination Light Assembly: Inspection

Apply battery voltage between the connector terminals to check the lighting condition of the light.

CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
Incorrect polarity connection may cause internal LED damage.

Courtesy of SUBARU OF AMERICA, INC.

Terminal No.	Inspection conditions	Specification
5 (+) - 6 (-)	Apply battery voltage.	Stop light on
1 (+) - 6 (-)		Tail/side marker light on
2 (+) - 6 (-)		Turn signal light on
3 (+) - 6 (-)		Back-up light on

Replace the harness and bulb if it is found defective.
NOTE: Since LED (Light Emitting Diode) is used for the tail light and stop light, replace the light assembly combination rear if the light does not illuminate.