Rear Sub Switch
- Measure the resistance between terminals of the switch assembly power window rear sub.
Preparation tool:
Circuit tester
- Rear seat sub
Terminal No. Inspection conditions Standard 5 - 6 OFF Less than 1 Ω 2 - 5
2 - 61 MΩ or more 2 - 6 Manual UP Less than 1 Ω 5 - 6
2 - 51 MΩ or more 2 - 5 Manual DOWN Less than 1 Ω 5 - 6
2 - 61 MΩ or more - Apply battery voltage between the switch power window sub rear terminals to check lighting condition of illumination inside the switch.CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side .
Incorrect polarity connection may cause LED damage inside the switch .Terminal No. Inspection conditions Standard 7 (+) - 2 (-) Apply battery voltage. Light ON - Replace the switch assembly power window rear sub if it is found defective from the inspection result.