Multi-Function Display Switch

Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Courtesy of SUBARU OF AMERICA, INC.

Normal type

Terminal No.	Inspection conditions		Standard
13 - 16	INFO	OFF	3 MΩ or more
13 - 16	INFO	ON	Approx. 30 Ω

High grade type

Terminal No.	Inspection conditions		Standard
13 - 15	Δ (UP) ENTER or VIEW (DOWN)	All OFF Δ (UP)	3 MΩ or more
	Δ (UP)	ON	Approx. 10 Ω
	ENTER or VIEW	ON	Approx. 470 Ω
	(DOWN)	ON	Approx. 1, 670 Ω

Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.

CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
Incorrect polarity connection may cause LED damage inside the switch.

Terminal No.	Inspection conditions	Specification
11 (+) - 4 (-)	Apply battery voltage.	Light ON

Replace the switch assembly hazard if it is found defective.