Engine Starting System & Charging System (Except For HEV): Starter: Assembly
- Apply grease to the shaft sliding surfaces of the internal gear.
Grease:
Multemp #6129 or equivalent
- Install the internal gear to the shaft.
- Install the overrunning clutch as follows:
- Install the overrunning clutch, internal gear, shaft and shift lever as a single unit to the starter housing.NOTE: Apply grease to the moving parts of the shift lever.
Grease:
Multemp #6129 or equivalent
- Apply grease to the inside of the internal gear and pinion gear, and attach the pinion gear to the internal gear assembly.NOTE: Apply grease evenly to the contact surfaces of each gear.
Grease:
Molykote® AG650 or equivalent
- Install the plate and seal rubber.
- Set the armature assembly to the yoke assembly.
- Attach the armature assembly and yoke assembly to the starter housing together as a single unit.NOTE: As shown in the figure, match the protrusion of the yoke assembly to the cut out of the starter housing.
- Use an appropriate tool (suitable attachment, etc.) to attach the brush holder assembly.NOTE: Be careful not to damage the brushes.
- Set the starter cover, and secure the brush holder assembly with bolts.
Tightening torque:
CVT model
3.4 N.m (0.3 kgf-m, 2.5 ft-lb)
MT model
1.4 N.m (0.1 kgf-m, 1.0 ft-lb)
- Install the through bolt.
Tightening torque:
CVT model
3.5 N.m (0.4 kgf-m, 2.6 ft-lb)
MT model
6 N.m (0.6 kgf-m, 4.4 ft-lb)
- Install the magnet switch assembly.
Tightening torque:
CVT model
3.4 N.m (0.3 kgf-m, 2.5 ft-lb)
MT model
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Connect the cable to the terminal M.
Tightening torque:
CVT model
10.7 N.m (1.1 kgf-m, 7.9 ft-lb)
MT model
10 N.m (1.0 kgf-m, 7.4 ft-lb)