Inspection Mode 2

Inspection steps:

1. Using the Subaru Select Monitor, perform the clear memory of [Telematics]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
2. Using the Subaru Select Monitor, read the DTC of [Telematics] to check that there is no DTC displayed. Ref. to TELEMATICS SYSTEM (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
   NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to the DTC. After solving the DTC, repeat from step 1).
3. Turn the ignition switch to OFF.
4. Close all doors. (The vehicle enters CAN sleep state.)
5. Wait for approx. 3 minutes. After the indicator goes off, wait for another 1 minute. (DCM standby mode)
6. Turn the ignition switch to ON, and wait for 5 seconds or more.
7. Using the Subaru Select Monitor, read the DTC of [Telematics] to check that there is no DTC displayed. Ref. to TELEMATICS SYSTEM (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
   NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to the DTC. After solving the DTC, repeat from step 1).