Combination Switch (Light): Installation

CAUTION:

Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
Do not allow harness and connectors to interfere or get tangled up with other parts.
If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC(VDC) Centering Mode" of the VDC. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM & H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .

Install the switch assembly combination turn dimmer.
1. Using pliers, loosen the clamp.
2. With the clamp loosened, insert so that the cutout of the column assembly steering and the claw of the switch assembly combination turn dimmer are aligned, and then engage them.
3. Install the clamp, and connect the connector.
  NOTE: When replacing with a new part, engage the claw first, and then pull out the securing pin of the clamp.
Install the switch assembly combination wiper. Ref. to WIPER AND WASHER SYSTEMS>COMBINATION SWITCH (WIPER)>INSTALLATION .
Install the steering roll connector. Ref. to AIRBAG SYSTEM>ROLL CONNECTOR>INSTALLATION .
Install the column cover assembly. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>STEERING COLUMN>INSTALLATION .
Install the steering wheel. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>STEERING WHEEL>INSTALLATION .
Install the driver's airbag module. Ref. to AIRBAG SYSTEM>DRIVER'S AIRBAG MODULE>INSTALLATION .
Install the cover LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .