Lighting System: General Description: Caution
- When performing service operation, refer to "Repair Contents" in "General Description". Ref. to REPAIR CONTENTS>REPAIR CONTENTS .
- Before disconnecting connectors of sensors or units, be sure to disconnect the ground terminal from the battery sensor.
- When replacing the parts provided with memory functions, record the memory contents before disconnecting the ground terminal from the battery sensor.
- Be careful of the following items. Failing to do so may cause the airbag system malfunction.
- Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
- Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column.
- When removing, installing or replacing the VDC control module and H/U, VDC control module and H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform "VSC(VDC) Centering Mode" of the VDC. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM & H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .
- Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.
- Always replace with a bulb that is the same model and wattage as those of the old one.