Hazard Switch: Inspection
- Measure the resistance between connector terminals.
Terminal No. Inspection conditions Standard 3 - 2 Switch OFF 1 MΩ or more Switch ON Less than 1 Ω - Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.CAUTION:
- When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
- Incorrect polarity connection may cause LED damage inside the switch.
Terminal No. Inspection conditions Specification 4 (+) - 1 (-) Apply battery voltage. Light ON - Replace the switch hazard if it is found defective.