Sunroof Motor: Installation
CAUTION:
- For installation of the cover assembly stereo camera, refer to "INSTALLATION", "Stereo Camera Cover" in the "EyeSight" article and observe the precautions for installation. Ref. to EYESIGHT>STEREO CAMERA>INSTALLATION .
- When installing the sunroof motor, be careful not to move the cable assembly.
- Install the motor assembly.
Tightening torque:
5.4 N.m (0.6 kgf-m, 4 ft-lb)
- Install the cover assembly stereo camera. Ref. to EYESIGHT>STEREO CAMERA>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- Perform the initialize operation. Ref. to SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)>SUNROOF CONTROL SYSTEM>OPERATION>INITIALIZATION .
- Check the operation of sunroof by following the table below.
| Operation | Switch position |
|---|---|
| (1) Glass lid closes completely. | Close |
| (2) Glass lid tilt up to the top position. | Tilt up |
| (3) Glass lid closes completely. | Tilt down |
| (4) Glass lid opens 368 mm (14.49 in) away from completely closed position. | Open |
| (5) Glass lid opens completely. | Open |
| (6) Glass lid closes completely. | Close |