FixVault
Home › Subaru › 2021 › Outback Base › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (CVT Transaxle System (Tr690)) › Oil Pump Chain › Removal

Oil Pump Chain: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the torque converter. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>TORQUE CONVERTER>REMOVAL .
  2. Remove the bolts which hold the oil pump chain cover.
    G13951158Courtesy of SUBARU OF AMERICA, INC.
  3. Pry the area shown in the figure with a crowbar or a similar tool wrapped with protective tape, and then remove the oil pump chain cover, oil pump sprocket and oil pump chain.
    G13951159Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the seal rings.
    G13951160Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the driven sprocket and oil pump chain.
    NOTE: The driven sprocket is a non-disassembly part.
    G13951161Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the snap ring and remove the drive sprocket.
    G13951162Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the oil seal using a flat tip screwdriver wrapped with protection tape.
    G13951163Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the liquid gasket from the oil pump chain cover and the converter case.
About FixVault