FixVault
Home › Subaru › 2021 › Outback Base › Repair and Diagnosis › Restraints › Restraints Control Systems › Seat Belt System › Rear Seat Belt › Installation › Belt Assembly Rear Out Ctr (Outback Model)

Belt Assembly Rear Out Ctr (Outback Model)

CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  • Side impact sensor (under the rear center seat) for the airbag system is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.
  1. Install the belt assembly rear OUT CTR.

    Tightening torque: 

    30 N.m (3.1 kgf-m, 22.1 ft-lb)

  2. Install the trim panel sub assembly. Ref. to EXTERIOR/INTERIOR TRIM>ROOF TRIM>INSTALLATION .
  3. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  4. After installation, check the following points.
    • The seat belt is not twisted.
    • The seat belt can be pulled out and retracted smoothly.
NOTE: While performing the winding inspection, place your hand on the tongue plate.
About FixVault