Destination Setting

NOTE: For the vehicle requiring the destination setting, if the destination setting is not finished, display can not be shifted into customizing screen.

CONFIRM CURRENT SETTING.
Always perform confirmation of current setting before replacing the module. Record the contents of the "Destination Setting".

NOTE: Refer to the "Read Current Data" and "CONFIRMATION OF CURRENT SETTING" to confirm the current setting. Refer to BODY CONTROL SYSTEM (DIAGNOSTICS)>REGISTRATION BODY INTEGRATED UNIT>OPERATION>CONFIRM CURRENT SETTING . Refer to BODY CONTROL SYSTEM (DIAGNOSTICS)>READ CURRENT DATA>OPERATEON .

Is the current setting recorded?

Yes: Go to 2.

No: Confirm the current setting. Go to 1.
CONFIRM DESTINATION SETTING.
1. Connect the Subaru Select Monitor, and run the application.
2. On «Start» display, select «Diagnosis».
3. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
4. On «Main Menu» display, select «Each System».
5. On «Select System» display, select «Body Control» and then select «Enter».
6. On «Select Function» display, select «Customize».
7. The vehicle destination screen is displayed.
Is the vehicle destination setting screen displayed?

Yes: Go to 3.

No: Go to 4.
CONFIRM DESTINATION SETTING.
Confirm the screen displayed on Subaru Select Monitor and the actual vehicle destination. Is it necessary to change the destination setting?

Yes: Select [Yes], Go to 4.

No: Select [No], Go to 5.
ENTER DESTINATION CODE.
Enter the appropriate code in the screen.

JPN: JP00

KA, KC: KA00

KS: KS00

U4, U5, U6, C6 and C0, C5 (with the keyless access with push button start system): U400

C0, C5 (without the keyless access with push button start system): C000

EK, ER: EK00

Except above: EC00

Is the appropriate code entered?

Yes: Select [OK]. Go to 5.

No: Enter the destination code. Go to 5.
REGISTER VEHICLE EQUIPMENT.
Customizing screen is displayed.

NOTE: Match the each item setting of body integrated unit registration item list with the vehicle equipment.

Do all setting contents match with the vehicle equipment specification?

Yes: Go to 6.

No: Change the items until each content setting match with the vehicle equipment specification. Go to 6.
CONFIRM MARKET MODE.
1. Customizing screen, select the {Factory initial setting} to change the setting from "Factory" mode to "Market" mode.
2. Turn the ignition switch to OFF.
  NOTE: When the setting is changed from "Factory" mode to "Market" mode, turning the ignition switch from ON → OFF confirms the setting.
3. Turn the ignition switch to ON, and check the contents of settings.
Is the mode changed to "Market" mode?

Yes: Go to 7.

No: Perform the destination setting from the first step. Go to 1.
CONFIRM MARKET MODE.
Check the following.

Make sure that the "Destination Setting" in the current data display is the same as the one you confirmed in step 1.

Is the display the same as indicated?

Yes: Registration of body integrated unit is finished.

No: It is possible that harness malfunction may occur. Perform the diagnosis.