Combination Switch (Light): Installation

CAUTION:

Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Refer to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
Do not allow harness and connectors to interfere or get tangled up with other parts.
If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC(VDC) Centering Mode" of the VDC. Refer to VEHICLE DYNAMICS CONTROL(VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDC CONTROL MODULE & H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .

Install the switch assembly - combination turn dimmer.
1. Using pliers, loosen the clamp.
2. Insert the switch assembly - combination turn dimmer so that the claw is engaged with the cutout of the column assembly - steering while the clamp is loose.
3. Install the clamp, then connect the connector.
  NOTE: If it is replaced with a new part, engage the claw before pulling out the fixing pin of the clamp.
Install the switch assembly - combination wiper select.
Install the steering roll connector. Refer to AIRBAG SYSTEM>ROLL CONNECTOR>INSTALLATION .
Install the cover assembly - column.
Install the steering wheel.
Tightening torque:

39 N.m (4 kgf-m, 28.8 ft-lb)

Clearance:

Between cover assembly - column and steering wheel: 4 - 6 mm (0.16 - 0.24 in)
Install the driver's airbag module. Refer to AIRBAG SYSTEM>DRIVER'S AIRBAG MODULE>INSTALLATION .
Connect the battery ground terminal. Refer to NOTE>NOTE>BATTERY .