Rear Combination Light Assembly: Inspection
- Apply battery voltage between the connector terminals to check the lighting condition of the light.
Terminal No. Inspection conditions Specification 6 (+) - 2 (-) Apply battery voltage. Stop light on 4 (+) - 2 (-) Tail/side marker light on 3 (+) - 2 (-) Turn signal light on 1 (+) - 2 (-) Back-up light on - Replace the harness and bulb if it is found defective.NOTE: Since LED (Light Emitting Diode) is used for the tail & stop light bulb, replace the light assembly - rear combination.