Rear Height Sensor: Installation
CAUTION:
Do not apply impact to the sensor assembly - headlight beam leveler or forcibly move the arm. Doing so may cause sensor damage and malfunction.
- Install the sensor assembly - headlight beam leveler.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the rear wheels.
Tightening torque:
120 N.m (12.2 kgf-m, 88.5 ft-lb)
- Lower the vehicle.
- Connect the battery ground terminal. Refer to NOTE>NOTE>BATTERY .
- Perform reinitialization of the auto headlight beam leveler system. Refer to LIGHTING SYSTEM>AUTO HEADLIGHT BEAM LEVELER SYSTEM>PROCEDURE>REINITIALIZATION .NOTE: When replacing the rear vehicle height sensor with a new part, perform the initialization. Refer to LIGHTING SYSTEM>AUTO HEADLIGHT BEAM LEVELER SYSTEM>PROCEDURE>INITIALIZATION .