Function Check Mode

Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
On «Start» display, select «Diagnosis».
On «Vehicle selection» display, input the vehicle information and select «Confirmed».
On «Main Menu» display, select «Each System».
On «Select System» display, select «Brake Vacuum Pump».
On «Select Function» display, select «Work Support».
On the «Work Support» display, select «Function Check Sequence».
When «Sequence Control Mode will be started» is shown on the screen, click the [OK] button.
When «Depress the brake pedal 5 times.» is shown on the screen, depress the brake pedal 5 times, and click the [OK] button while the brake pedal is not depressed.
Click the [OK] button after the "OK" is displayed.

NOTE: For detailed operation procedures, refer to "Application help".